- Member ID
- #2718
- Messages
- 330
- Reactions
- 873
- Likes
- 117
- City
- Whitehouse
- State
- TX
- Country
- United States
- Vehicle
- 2016 Challenger Hellcat
Used Magnuson TVS2650R Stage 2, this was ran on a 2016 Dodge Challenger Hellcat and has about 800 miles on this setup, currently set with the max effort pulley set-up. Includes the pulley combinations to run with a stock 6.2 engine also. On the stock pulley set-up with 1050id injectors this setup made 1056rwhp. Includes the following parts: 108mm Gearhead Fabrications throttle body, extra belts, 3.00”, 3.25”, 3.50” shaft pulleys, the 30, 32 and 34 tooth rear cog pulleys and belts, an ARS shaft tensioner and a Big Johns Dual Idler pulley set-up. Includes everything necessary to install except for one adapter bushing will be needed for the water lines and it can be purchased from Magnuson. Does not include injectors, fuel pumps or air intake. I am going to a new set-up on this car and this one needs to go. It is currently installed on my car and will be removed when sold, the car will not be driven/raced again until this set-up is removed. The Maggie will be removed at Bailys Hyperformance in FT Worth, Texas and can be picked up there or I can ship it. $5,000.00 and I will entertain cash offers.
Attachments
-
2 MB Views: 31
-
1.9 MB Views: 35
-
1.7 MB Views: 30
-
1.5 MB Views: 26
-
1.1 MB Views: 26
-
944.7 KB Views: 27
Last edited:
- 4
- Show All